Pro Power Amplifier

QSC RMX 1450 2-Channel Professional Power Amplifier 280W @8? / 1400W @4


QSC RMX 1450 2-Channel Professional Power Amplifier 280W @8? / 1400W @4
QSC RMX 1450 2-Channel Professional Power Amplifier 280W @8? / 1400W @4
QSC RMX 1450 2-Channel Professional Power Amplifier 280W @8? / 1400W @4
QSC RMX 1450 2-Channel Professional Power Amplifier 280W @8? / 1400W @4
QSC RMX 1450 2-Channel Professional Power Amplifier 280W @8? / 1400W @4
QSC RMX 1450 2-Channel Professional Power Amplifier 280W @8? / 1400W @4
QSC RMX 1450 2-Channel Professional Power Amplifier 280W @8? / 1400W @4
QSC RMX 1450 2-Channel Professional Power Amplifier 280W @8? / 1400W @4
QSC RMX 1450 2-Channel Professional Power Amplifier 280W @8? / 1400W @4

QSC RMX 1450 2-Channel Professional Power Amplifier 280W @8? / 1400W @4    QSC RMX 1450 2-Channel Professional Power Amplifier 280W @8? / 1400W @4
This listing includes one QSC RMX 1450 2-Channel Professional Power Amplifier. Cosmetically in very clean overall condition showing light signs of use/wear. Amplifier includes the power cable as shown in the photos. Amplifier was recently pulled from a working facility and is Guaranteed for 30 Days. Please review all photos and be sure to ask any questions. Output Wattage, Stereo Mode (EIA: both channels driven). 8 ohms EIA 1 kHz 0.1% THD: 280W. 4 ohms EIA 1 kHz 0.1% THD: 450W. 2 ohms EIA 1 kHz 1% THD: 700W. Output Wattage, Bridge Mono Mode.

8 ohms EIA 1 kHz 0.1% THD: 900W. 4 ohms EIA 1 kHz 1% THD: 1400W. Signal to Noise (20 Hz-20 kHz): 100dB.

Distortion (SMPTE-IM): Less than 0.01%. Voltage Gain: 40x (32 dB).

Distortion (typical): 20 Hz-20 kHz: 10 dB below rated power: Less than 0.03% THD 4 and 8 ohms. 1.0 kHz and below: full rated power: Less than 0.03% THD 4 and 8 ohms. Frequency Response: 20 Hz-20 kHz, 0/-1 dB, -3 dB points: 5 Hz-50 kHz. Damping Factor (1 kHz and below): greater than 300 at 8 ohms.

Input Impedance: 10 K ohms unbalanced, 20 K ohms balanced. Input Clipping: 10 Vrms (+22dBu). Cooling: Continuously variable speed fan, rear-to-front air flow.

Connectors (each channel): Input: Active balanced; barrier strip, XLR, and 1/4 (6.3 mm). TRS tip and XLR pin 2 positive.

Output: "Touch-proof" binding posts and Neutrik Speakon. Controls: Front: AC switch, Ch. Indicators: PWR-ON: Green LED SIGNAL: Yellow LED (1 per channel) CLIP: Red LED (1 per channel). Amplifier Protection: Full short circuit, open circuit, thermal, ultrasonic, and RF protection.

Stable into reactive or mismatched loads. Load Protection: Turn-on/off muting, AC coupling (850, 1450), triac crowbar (2450, on each channel). Power Requirements: 100, 120 VAC, 50-60 Hz.

Dimensions: rack mounting: 48.3cm (19"); 8.9cm (3.5") tall (2 rack spaces); 40cm (15.9) deep (rack mounting to rear support ears). Is FREE (Lower 48 States Only). This item is in the category "Musical Instruments & Gear\Pro Audio Equipment\Amplifiers". The seller is "tubejunkie" and is located in this country: US.

This item can be shipped to United States.

  1. Number of Channels: 2
  2. Model: QSC RMX 1450
  3. Type: Power Amplifier
  4. Color: Black
  5. Brand: QSC


QSC RMX 1450 2-Channel Professional Power Amplifier 280W @8? / 1400W @4    QSC RMX 1450 2-Channel Professional Power Amplifier 280W @8? / 1400W @4